Dual Power Automatic Transfer Switch
Dual Power Automatic Transfer Switch

Dual Power Automatic Transfer Switch

Thank you for using our products, we believe this product willgive your work and life benefits and convenience, welcome yourvaluable suggestions and comments in the use course, we will continueto provide you with enthusiastic and attentive service.
Send Inquiry

 

DUAL POWER AUTOMATIC TRANSFER SWITCH

 

Thank you for using our products, we believe this product willgive your work and life benefits and convenience, welcome yourvaluable suggestions and comments in the use course, we will continueto provide you with enthusiastic and attentive service.

 

Control device: built in controller:

 

Product structure: no power off, guide rail type, high current, small volume, two-stage type.simple structure, ATS integration
Features: fast switching speed, low failure rate, convenient maintenance and reliableperfomance
Wiring mode: front plate wiringConversion mode: power grid to power grid, power grid to generator, photovoitaic to urbanpower, automatic switching and self recoveryProduct frame: 100
Product curent: 10,16,20,25,32,40,50,63,80,100A
Product classification: direct load type
Pole No.:2.3,4
Standard:GB/T14048.11
A T S E: PC class
Switching time: 0.008s/8ms

 

Main technical parameters:

product-830-792

 

Matters needing attention:

 

ManuaVautomatic operation
ATS can guarantee the perfomance of power generation and power failure duringcircuit operation, but for manual operation, ATS cannot guarantee the above perform-ance due to the difference of power generation and power failure speed or operator.During manual power generation and power failure, excessive silver alloy loss mayoccur. Therefore, when all power supplies are cut off to check and maintain theoperating system and contacts, it is only necessary to pull the selector switch to themanual position, Under normal circumstances, please pull the selector switch to theautomatic position, When operating manually, pull the selector switch to the manualposition, After the manual operation is completed, pull the selector switch from themanual position to the automatic position.

 

Control circuit:

 

ATS instantly becomes active. After the conversion is completed, the coil in thecontrol circuit will be disconnected by the intemal converter. Under the rated voltageof 80%-110%, the coil can operate normally. Low voltage will cause coil heating andeven spontaneous combustion.

 

 

 

 

 

Hot Tags: dual power automatic transfer switch, China dual power automatic transfer switch manufacturers, suppliers, factory, Molded Circuit Breaker, Protective Switch, Air Circuit Breaker, Mccb Moulded Case Circuit Breaker, Abb Molded Case Circuit Breaker, Molded Case Breakers